Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Modern flush
LiftMaster openers
Before
After
Before
After
Before
AfterGarage Door Before & After in Sandy Springs, GA
Anyone can claim they do clean work. We’d rather show you the evidence. These are the kinds of transformations our technicians complete across Sandy Springs every week, from Riverside Drive to the Perimeter, each one documented with the same photo record we hand to the customer before we leave. No staged shots, no stock photos. Just what a garage door looks like after it’s been properly repaired, replaced, or rebuilt by people who write the price down before the first tool comes out.
Recent Transformations
Torsion Spring Replacement on a 16-Foot Clopay Door
The door wouldn’t lift past the second panel, and the homeowner had already pulled the emergency release twice trying to force it. When our technician arrived, the right-side torsion spring measured 0.225-inch wire diameter and showed a clean break at the coil, about 14 inches from the winding cone. We replaced both springs as a matched pair, rebalanced the door at full travel, and photographed the broken spring on the workbench before quoting anything. The result: the door opens with one hand again, and the customer got a written warranty on the new springs plus the photo record of the failed part.
Full Panel Replacement for a Wayne Dalton Door After a Vehicle Strike
A teenager backing out of the garage caught the door before it had fully raised, buckling the bottom three panels and throwing the track alignment off by nearly half an inch on the right side. The door was a Wayne Dalton 9600 series, and the panels were still available through our parts supplier, so we quoted a panel replacement rather than a full door swap. We pulled the damaged panels, reset the track brackets, and reinstalled with new hinges and rollers in the affected sections. The door now runs quiet and seals flush against the floor, and the repair cost about 60 percent of what a new door would have run.
Garage Door Opener Replacement: LiftMaster Logic Board Failure
The opener would hum for two seconds and stop, which usually points to either the capacitor or the logic board. Testing showed the board had a burned trace near the relay, and on a 2014 LiftMaster the cost of the board plus labor made a new opener the smarter call. We replaced it with a current-model LiftMaster with the same rail configuration, reprogrammed the vehicle remotes, and set the limit switches for the door’s exact travel. The homeowner got the old board back in a bag, a photo of the failed trace, and a flat written price before we started. That’s just how we work.
Full Door Replacement: 18-Year-Old Amarr Door to a New Clopay Steel Back
The original door was an Amarr from 2007, and it had reached the point where the bottom panel was rotting at the corners, two rollers had flat spots, and the center stile had cracked through where the opener arm attached. Patching it would have bought maybe another year, so we quoted a full replacement with a Clopay 4050 steel back insulated door. We reused the existing track where it was solid, replaced all the rollers and hinges, and set the new door’s weight against the existing springs. The difference in how the door moves is the first thing the homeowner noticed, and the R-value jump from the old uninsulated panel is a bonus for a garage that faces the afternoon sun in Sandy Springs.
Roller and Hinge Rebuild with Track Realignment on a Craftsman Door
This door sounded like a freight train every time it opened, and the homeowner had been tolerating it for two years. The rollers were original to the door, which meant nylon wheels worn down to the bearing in six places. We replaced all ten rollers, swapped the hinges that had play, and realigned the left track, which had drifted outward at the header. The door now moves at about half the noise level and doesn’t shudder at the top of the arc. Total job ran about two hours, and the customer saw every worn part laid out on the floor before we installed the new ones.
Emergency Same-Day Repair: Snapped Cable on a Genie Door
We took this call at 10 p.m. on a Tuesday. The right-side lift cable had snapped where it passed over the drum, leaving the door hanging at a dangerous angle with all the tension on one side. Our technician arrived, secured the door, replaced both cables as a pair, reset the drum spacing, and had the door balanced and running by midnight. The homeowner got the same written scope and photo record as any daytime job, plus the flat price before work started. That’s what 24/7 emergency service should look like: a real person answering the phone and a named technician showing up.
Want Results Like These?
Every job above started with one phone call to (470) 944-6743. You’ll get a real person on the line, a named technician dispatched, and a flat written price before any work begins. That’s Clause 1 of The Haven Standard, and we’ve held to it since 2015. Whether it’s a broken spring, a failed opener, or a full door replacement in Sandy Springs, the process is the same: written price first, photo record after, and a door that works right.
Written by Marcus Deller, Owner at Servo Garage Doors Sandy Springs, serving Sandy Springs since 2015.